DIP switch function introduction

by default, all DIP the switches are all in " OFF” state.

DIP switch 1－thermosensitive /thermal transfer should be switched. if you are printing heat-sensitive materials, you can move the DIP turn switch "1" (counting from top to bottom) to ON state.

DIP switch 2－swing settings. if you need to tear off a label when printing a label, you can remove the label behind the barcode printer. DIP turn switch "2" to ON state.

DIP switch 3－cutter settings. if you want to print with a cutter, you can move the DIP turn switch "3" to ON state.

DIP switch 4－peeler settings. if you want to print with a paper peeler, you can put the DIP turn switch "4" to ON state.

DIP switch 5－paper sensing mode settings. default state ( OFF） below, the printer paper sensing method is reflective. if you want to adjust the printer sensing mode to transmissive, you can change the DIP turn switch "5" to ON state.

DIP switch 6－network card settings. if your printer is equipped with a network card and needs to use it, please refer to the network card settings instructions. DIP switch "6" to set accordingly.

DIP switch 7&8 －serial port baud rate setting. the baud rate in various cases is:

7 OFF | 8 OFF：9600

7 ON | 8 OFF：19200

7 OFF | 8 ON：38400

7 ON | 8 ON：78600(57600)